Specifications

Torque:
400 foot Pounds

Liquid Velocity:
25,000 gpm

Speed:
Constant

Agitator Surface Area:
N/A

Normal Operation:
1100 RPM

Installed Weight:
100 lbs.

Drive

Power Source:
40HP Truck wet line PTO

Hydraulic Pump:
3000 PSI design, 30 gpm

Hydraulic Motors:
3500 PSI design (high torque) Gear Type

Materials

Blades and Supports:
Aluminum or Stainless Steel

Shafts:
316ss

Bearings:
TEFLON

Hardware:
316ss

Performance

Fluid viscosity to 14,000

SSU solids greater than 70% to 1.9SG

Temperature to 170°F

Dry to Wet

"Fill to maximum vehicle weight dry, add liquid at destination and deliver slurry."

Sumter Transport announces the availability of its Pneumatic Tank agitator for the maximum in transportation cost savings. Sumter Transport applies its proven years of agitation systems technology to the blending of dry products with liquids. This system is operated using the engine from the tractor to a power take off system that operates a hydraulic pump located on the unit. This pump turns the four hydraulic motors that are mounted on the top of the tanker. Each motor has a shaft attachment with mixers that can provide up to 40 horsepower of blending per cone. A PLC unit located on the street side of the tanker can operate the mixers independent of each other, or all four can be operated at the same time. Unloading time is greatly reduced by the use a six-inch discharge pipe located on the underside of the tanker.

  • 1600 cubic foot dry (installable in any size tanker)
  • 11,960 gallons
  • High speed blending units
  • Fully self contained
  • Computer controlled
  • Freight savings
  • Ship more product (Up to 75% more!)
  • Maximize and incorporate full use of plant site
  • Transform dry plant to slurry plant
  • On-site blending capability